Path: utzoo!attcan!utgpu!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!cwjcc!hal!nic.MR.NET!tank!mimsy!haven!purdue!decwrl!labrea!agate!helios.ee.lbl.gov!lll-tis!lll-ncis!lll-lcc!rzh
From: rzh@lll-lcc.llnl.gov (Roger Hanscom)
Newsgroups: sci.electronics
Subject: Homemade Printed Circuit Boards
Keywords: strange ways
Message-ID: <2101@lll-lcc.llnl.gov>
Date: 12 Nov 88 02:19:48 GMT
Distribution: na
Organization: Lawrence Livermore Labs, LCC, Livermore Ca
Lines: 17


Will somebody out there offer some sage advice about making
one-sies printed circuit boards??  I've tried some *REALLY*
strange ways to do this, but none of them worked out very
well.  One of the more difficult things for me to do is drill
the %$*^&@ things.  If there are lots of ICs on the board,
drilling for 14/16/24 pin dips becomes nearly impossible to
do well.  Keep in mind that I have a limited budget to work
with here!  Anyone know of a firm that will make boards from
artwork for a reasonable price??  Do these dry tranfer etch
patterns really work??  (but then you're stuck with the
drilling problem again!)  HELP.
                           Roger
<------------>
   {ucbvax,ames,lll-crg,....}!lll-lcc!freedom!rzh
   or {ucbvax,ames,lll-crg,....}!lll-lcc!rzh
   or rzh%freedom.llnl.gov@lll-lcc.llnl.gov