Path: utzoo!attcan!utgpu!watmath!clyde!att!osu-cis!killer!crlabs!bartal!phillip
From: phillip@bartal.CRLABS.COM (Phillip Vogel)
Newsgroups: sci.electronics
Subject: Homemade Printed Circuit Boards
Message-ID: <7.237D02C1@bartal.CRLABS.COM>
Date: 13 Nov 88 03:12:33 GMT
Organization: Bartal Design Group, Inc. Englewood, NJ
Lines: 19


 > From: rzh@lll-lcc.llnl.gov (Roger Hanscom)
 > Date: 12 Nov 88 02:19:48 GMT
 > Organization: Lawrence Livermore Labs, LCC, Livermore Ca
 >
 > Will somebody out there offer some sage advice about making
 > one-sies printed circuit boards??  I've tried some *REALLY*
 > strange ways to do this, but none of them worked out very
 > well.  One of the more difficult things for me to do is drill
 > the %$*^&@ things.  If there are lots of ICs on the board,
 >                            Roger
 A trick that I use often (for adding chips to existing boards) is to use a
piece of perf board as a drilling template. the holes come out lined up just 
fine.
 --  
Phillip M. Vogel - Bartal Design Group, Inc. - Englewood, NJ
201-567-1343       201-569-7667 ext.239       800-631-2524 ext.239
DOMAIN: phillip@bartal.CRLABS.COM   UUCP: killer!crlabs!bartal!phillip
DISCLAIMER: Hell, I OWN the company !