Path: utzoo!utgpu!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!cs.utexas.edu!sm.unisys.com!csun!csuchico!fenris
From: fenris@csuchico.EDU (Chris Anderson)
Newsgroups: comp.dcom.modems
Subject: Telebits Trailblazer +
Message-ID: <1147@csuchico.EDU>
Date: 16 Dec 88 18:08:29 GMT
Reply-To: fenris@csuchico.UUCP (Chris Anderson)
Distribution: na
Organization: California State University, Chico
Lines: 32

We just got in some TrailBlazer Plus's, and I'm trying to
get them to work with uucp and cu. Can anybody give me some
advice?

We've got both hdb uucp and version 2(?), and I need the conf.
for both.  What I've done so far (for hdb) is to set the modem
with the following string:
	at &f s51=254 s52=2 s54=3 s110=1 s111=30 s45=0 q6 &w
Devices looks like this:
	ACU ttyxx - 9600 tb9600
Dialers looks like this:
	tb9600  =W-   "" A\pA\pA\pT OK ATS50=255DT\T CONNECT\sFAST

What's happening is that the modem makes the connection (we get
a CONNECT string back) and then hangs.  Data sent through (via
keyboard/cu) is not reflected on the screen, and doesn't appear
to affect the remote system.  I cannot get it back to command 
mode, basically to reset it I have to turn it off/on.

Also, I'm not sure if the modem on the other end is going to
be a Telebits or ???.  We definitely need it to be able to 
connect with a Hayes modem.

It's probably something *really* stupid that I've done, but this
has me stumped (ie I don't have a lot of time to work on it :-))
Any info would be greatly appreciated!

Thanks in advance!

-- Chris Anderson		UUCP: ihnp4!csun!csuchico!fenris
   QMA, Inc.
need to be configured