Xref: utzoo comp.sys.atari.st:12952 comp.lang.modula2:1172
Path: utzoo!attcan!uunet!ncrlnk!ncrcae!hubcap!gatech!ncar!mailrus!tut.cis.ohio-state.edu!rutgers!mcnc!houser
From: houser@mcnc.org (Kevin D. Houser )
Newsgroups: comp.sys.atari.st,comp.lang.modula2
Subject: Modula2 Midi Programming Help!
Keywords: MODULA2 MIDI BYTE HELP
Message-ID: <3818@alvin.mcnc.org>
Date: 15 Dec 88 14:30:14 GMT
Organization: Microelectronics Center of NC; RTP, NC
Lines: 21


 In an effort to dump data to the midi ports on my Atari ST the following
code was tried:

     VAR
       i:BYTE;
     BEGIN
       i:=$90
          ^
           
 The compiler returned with a type not compatible error. So, how do I
assign an 8bit value to the variable <i>? I am new to Modula2, so it may
be trivial; but it is very important. Any help would be greatly appreciated.
(I'm using TDI-Modula2/ST by the way)

Thanx,
Kevin Houser
houser@mcnc.org
(919) 859-5467 H
(919) 248-1996 W