Path: utzoo!attcan!uunet!lll-winken!lll-lcc!ames!ucsd!sdcc6!sdcc10!cs161agc
From: cs161agc@sdcc10.ucsd.EDU (John Schultz)
Newsgroups: comp.sys.amiga.tech
Subject: Re: 2090A speed
Message-ID: <34@sdcc10.ucsd.EDU>
Date: 16 Dec 88 04:56:50 GMT
References: <9472@gryphon.COM> <1154@esunix.UUCP> <5379@leadsv.UUCP>
Reply-To: cs161agc@sdcc10.ucsd.edu.UUCP (John Schultz)
Organization: University of California, San Diego
Lines: 16

In article <5379@leadsv.UUCP> kallaus@leadsv.UUCP (Jerry Kallaus) writes:
>Interleave    ....should be "0" for ST506 drives....
>(and on page 38, under Specification/Performance/HardDisk ST506)
>Sector Interleave   1:1
>I suspect that the mountlist interleave is ignored for an ST506 device.
>Jerry Kallaus         {pyramid.arpa,ucbvax!sun!suncal}leadsv!kallaus


  Read further: interleave is specified as x:y = x-y, so 1:1 = 0,
2:1 = 1, 3:1 = 2, etc.  Just installed a 251-1 today with a 2090A,
cool reboot times, looks quite snappy so fa'.



 John Schultz

 ...now studying brain waves at Scripps with an Amiga...