Path: utzoo!attcan!uunet!lll-winken!lll-tis!ames!netsys!len
From: len@netsys.COM (Len Rose)
Newsgroups: comp.sys.att
Subject: Re: Adding 70M disks to 3b2
Keywords: 3b2, non-standard disk addon's
Message-ID: <11042@netsys.COM>
Date: 14 Dec 88 15:20:29 GMT
References: <6997@batcomputer.tn.cornell.edu>
Reply-To: len@netsys.COM (Len Rose)
Distribution: comp
Organization: Netsys,Inc.
Lines: 22

I take it you formatted the drive first with IDTOOLS,or DEVTOOLS?
If you did ,and tried to load your unix distribution without success,
then maybe the person who said you had a bad cable MAY be correct.But,
if you did not format it first with one of the two pieces of software 
above,then obtain and try again..I have two machines here that have 
Micropolis 1325's (72 meg) drives installed w/o the slightest problem.
Note: After formatting the new drive,and re-loading unix from floppy,
you will get disk sanity errors,but they are to be ignored as Unix will
load anyway and then will create the partition. That should be the only
time you see that message.

To address your question about adding a drive via the expansion disk
connectors, just obtain the proper ST506 cables (data and control),make
sure the terminator and drive select is correct and format..
Then choose the dual disk upgrade selection from the menu you see when
booting the Unix distribution disks.

Practically ANY ST506/412 drive can be used in the 3B2/3XX/400 .. With
minimal work too,I might add.


len@netsys.com
{ames,att,rutgers}!netsys!len