Xref: utzoo comp.unix.questions:10783 comp.unix.wizards:13580
Path: utzoo!utgpu!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!rutgers!bellcore!faline!thumper!gamma!pyuxp!pyuxe!pyuxf!mxb
From: mxb@pyuxf.UUCP (Michael Brochstein)
Newsgroups: comp.unix.questions,comp.unix.wizards
Subject: Device driver needed for NEC Monograph monitor (to Xenix)
Keywords: Device Driver NEC Monograph Xenix
Message-ID: <467@pyuxf.UUCP>
Date: 19 Dec 88 18:10:28 GMT
Organization: Bell Communications Research
Lines: 14


	I recently pruchased a NEC Monograph monitor for my 286 AT computer
which runs Xenix.  The monitor works great under the DOS partition but
the machine won't even boot under Xenix.  I figure the CGA emulation on the
monitor's controller card is not good enough for Xenix.  I am guessing that
an appropriate device driver would solve the problem.  Does anyone have any
recomendations?  Please respond via e-mail or voice phone.

(212) 678-7881-home

-- 
Michael Brochstein                             Currently at Bellcore/PY4-S343
(201) 699-7177-work                                            Piscataway, NJ
DISCLAIMER: Bellcore doesn't consult me in most matters.