Path: utzoo!utgpu!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!csd4.milw.wisc.edu!uwmcsd1!lakesys!mikes
From: mikes@lakesys.UUCP (Mike Shawaluk)
Newsgroups: comp.sys.amiga
Subject: Re: DMCS won't print under 1.3
Keywords: Deluxe 1.3 choke
Message-ID: <256@lakesys.UUCP>
Date: 29 Dec 88 13:15:48 GMT
References: <840@wasatch.UUCP>
Reply-To: mikes@lakesys.UUCP (Mike Shawaluk)
Organization: Lake Systems - Milwaukee, Wisconsin
Lines: 23

In article <840@wasatch.UUCP> u-jmolse%sunset.utah.edu.UUCP@wasatch.UUCP (John M. Olsen) writes:
>
>I just picked up Deluxe Music Construction Set, and found that it only 
>produces printed output under v1.2 of the OS.  Has anyone else run into 
>this problem?  Has anyone figured out a way around it (besides going 
>back to 1.2)?
>
I don't know what you're doing that's different than what I did, but I've
been able to get it to work just fine!  Besides the obvious stuff (i.e, you
DID remember to run 1.3 Preferences & set everything up, right :-), make sure
you have the new printer.device, etc., on your DMCS boot disk (BTW, you did
not mention if you are running off of floppies, or hard disk, and, if the
latter, if you are running FFS or whatever.  My setup is floppy based, at
least for the next couple of weeks, while I wait for my hard drive to arrive
:-) :-) :-)

Leave me email if you have further info or questions; I'm sure we can figure
out what the problem is.  I for one am really pleased with the improvements
I've gotten with the new printer drivers (BTW, something else just occurred
to me; how much RAM do you have?  I have 1.5 meg!)
-- 
   - Mike Shawaluk
     ...!uunet!marque!lakesys!mikes