Path: utzoo!utgpu!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!rutgers!ucsd!nosc!humu!uhccux!lee
From: lee@uhccux.uhcc.hawaii.edu (Greg Lee)
Newsgroups: comp.sys.amiga
Subject: Re: Asking for information on Diamond Scan monitors
Message-ID: <2901@uhccux.uhcc.hawaii.edu>
Date: 30 Dec 88 13:50:19 GMT
References: <9133@ut-emx.UUCP>
Organization: University of Hawaii
Lines: 18

From article <9133@ut-emx.UUCP>, by mjl@ut-emx.UUCP (Maurice LeBrun):
" I am in the market for a new monitor for my 1000 since my 1080 died,
" and am seriously considering getting a Mitsubishi Diamond Scan.  A

I've had one for about 6 months now.  Works fine, except the display
is a little dimmer now than when it was new.  Maybe because I keep
it on continuously, with contrast and brightness turned down when
I'm not using it.

The color balance on mine changes slowly for around 20 minutes after
it's turned on.

I have to unplug the cable to my Amiga in order to reboot.  Probably
I didn't make the cable quite right.  Sawing off the end of an
rs232 connector and soldering all those tiny little wires was
a pain.  There must be a better way ...

		Greg, lee@uhccux.uhcc.hawaii.edu