Path: utzoo!utgpu!watmath!clyde!att!occrsh!uokmax!mcmiller
From: mcmiller@uokmax.UUCP (Michael C Miller)
Newsgroups: comp.sys.ibm.pc
Subject: XT controller use in AT?
Message-ID: <2174@uokmax.UUCP>
Date: 26 Dec 88 04:33:38 GMT
References: <18468@agate.BERKELEY.EDU> <12933@cup.portal.com>
Reply-To: mcmiller@uokmax.UUCP (Michael C Miller)
Organization: University of Oklahoma, Norman, OK
Lines: 12
Distribution:usa

Does anyone know if an XT FDC will work on an AT clone. I have been
told that it will work under certain conditions but haven't had any
luck. I have DTK BIOS, is this the problem ? I wonder if there will
be any limitations other than speed of transfer. My 286 runs 12MHz,
will this out run the XT hardware ? (My CGA and ports work fine.)
thanks.. (sorry if this is  an old topic but i'm new to the 286 )
					.....sans

-- 
<  sans =>   mcmiller@uokmax.UUCP   or  mcmiller@uokmax.ecn.uoknor.edu  > 
< Abe said 'where you want this killin' done ?'                         >
<   God said  ' out on highway 61 '					>