Path: utzoo!attcan!uunet!lll-winken!lll-lcc!ames!ncar!mailrus!cornell!uw-beaver!rice!sun-spots-request
From: wag@sun.com (Rick Wagoner)
Newsgroups: comp.sys.sun
Subject: Re: things to be careful of when swapping a 3/60 board
Message-ID: <8812231650.AA12691@georwell.>
Date: 4 Jan 89 21:54:58 GMT
Sender: usenet@rice.edu
Organization: Sun-Spots
Lines: 29
Approved: Sun-Spots@rice.edu
Original-Date: Fri, 23 Dec 88 08:50:10 PST
X-Sun-Spots-Digest: Volume 7, Issue 88, message 7 of 9
X-Issue-Reference: v7n72

The following change needs to be made to the original article:

	4		Installed memory (don't be surprised if this
			happens to be zero...and you get "Checking
			0 memory"), set it to the number of Mbytes
			of memory you have.
SHOULD BE:


	14		Installed memory.  In reality this location serves
			no purpose.  See next location:
ADD:

	15		The amount of memory to test in NORMAL mode.
			This should always be set to the amount of memory
			installed or greater.

	1B - 1D		Add these to the 19 -1A cautions.

	22 - 26		Diagnostic boot path:  These location perform the
			same functions as 19 - 1D, but are interogated when
			the system tries to boot in the DIAG mode.

When in doubt, check the Prom Users Guide ( Brown Tabs ) in the 4.0 Docubox.

Merry Christmas !!

Rick Wagoner
sun!rwagoner