Path: utzoo!utgpu!bnr-vpa!bnr-fos!bnr-public!hwt
From: hwt@bnr-public.uucp (Henry Troup)
Newsgroups: comp.lang.postscript
Subject: Re: Setting manual feed on a Laserwriter
Message-ID: <241@bnr-fos.UUCP>
Date: 11 Jan 89 14:40:37 GMT
References: <2976@uhccux.uhcc.hawaii.edu>
Sender: news@bnr-fos.UUCP
Reply-To: hwt@bnr-public.UUCP (Henry Troup)
Organization: Bell-Northern Research, Ottawa, Canada
Lines: 25

In article <2976@uhccux.uhcc.hawaii.edu> julian@uhccux.uhcc.hawaii.edu (Julian Cowley) writes:
>After successive attempts to print on both sides of a page on a
>Laserwriter using the manual feed, I can only conclude that it
>is done through software.  
>
>julian@uhccux.uhcc.hawaii.edu
>uunet!ucsd!nosc!uhccux!julian
>julian@uhccux.bitnet
 
The following PostScript fragment sets manual feed.  You'll need to
include it as a dvi /special appropriately to your system.
Manual feed will be turned off at the end of the job.  
 
Information obtained from the Abode red book.
 
% PostScript for manual feed 
 
statusdict begin
/manualfeed true store
end


utgpu!bnr-vpa!bnr-fos!hwt%bnr-public | BNR is not 	| All that evil requires
hwt@bnr (BITNET/NETNORTH) 	     | responsible for 	| is that good men do
(613) 765-2337 (Voice)		     | my opinions	| nothing.