Path: utzoo!attcan!uunet!cbmvax!joe
From: joe@cbmvax.UUCP (Joe O'Hara)
Newsgroups: comp.sys.amiga
Subject: Re: Lock fails on DH0: with A2090A
Message-ID: <5700@cbmvax.UUCP>
Date: 16 Jan 89 20:06:50 GMT
References: <1176@esunix.UUCP>
Reply-To: joe@cbmvax.UUCP (Joe O'Hara)
Organization: Commodore Technology, West Chester, PA
Lines: 22

In article <1176@esunix.UUCP> blgardne@esunix.UUCP (Blaine Gardner) writes:
>I have the A2090A autobooting an ST506 drive. DH0: is a 136K partition
>used to boot the system, and hand off to my first FFS partition.
>
>When I lock either of my FFS partitons it works fine, but 
>
>"Lock dh0: on"
>
>returns the message
>
>"Attempt to change lock failed"
>

The LOCK command is specific to FastFileSystem partitions. DH0: is a
standard filesystem. See page 2-18 of the 1.3 Enhancer manual.
-- 
========================================================================
  Joe O'Hara                ||  Comments represent my own opinions,
  Commodore Electronics Ltd ||  not my employers. Any similarity to
  Software QA               ||  to any other opinions, living or dead,
                            ||  is purely coincidental.
========================================================================