Path: utzoo!attcan!uunet!lll-winken!ames!pasteur!ucbvax!WUVMD.BITNET!C70301RC
From: C70301RC@WUVMD.BITNET (Rob Caton)
Newsgroups: comp.sys.apple
Subject: HELP!! (Modem Set-up, part 2)
Message-ID: <8901101517.aa29243@SMOKE.BRL.MIL>
Date: 10 Jan 89 19:08:09 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 35

I forgot to include some info in my last posting.  The default setup
for the Practical Peripherals 1200SA are as follows:

sw1:  Ignore DTR
sw2:  Full-word result codes
sw3:  Result code enabled
sw4:  Command Echo ON
sw5:  Auto Ans. disabled
sw6:  Ignore DCD
sw7:  Not used
sw8:  Enable commands
sw9:  BELL 103/212A
sw10: M/S Ratio - USA

Right now when I connect, garbage characters appear anytime the BBS
prompts me for input.  In other words, I can read what the BBS is sending
me, but I can't send anything back because it inserts garbage.  At almost
every prompt the "{" character appears, and my typing appears as random
characters.  By the way, this is when I am using Apple Access //.  My
Applelink disk dials and connects, but then is stays on connect for
about 30 seconds, hangs up, calls the second number, hangs up, and comes
back with the "error code #01" message.  Everything worked fine with
my 300 bps switchless Prometheus modem, but that's gone now.  Can anyone
help me?  Thanx!!

---------------------------------------------------------------------
|       Rob Caton          |BITNET:  C70301RC@WUVMD                 |
|--------------------------|APPLELINK:  RobCaton <==(How original:-)|
|(Area Under Construction) |COMPU$ERVE:  71450,754                  |
|====================================================================
| "ACK THIPPFFT"  _   /|   | Don't blame me;  |
|    --Bill        'O.O    | I voted for Bill |
|      the        =(___)=  | and Opus!!!      |
|      Cat           U     |                  |
-----------------------------------------------