Path: utzoo!attcan!uunet!lll-winken!ames!mailrus!cornell!hal
From: hal@aya.cs.cornell.edu (Hal Perkins)
Newsgroups: comp.sys.mac
Subject: SuperLaserSpool (was Re: nVIR ...)
Message-ID: <24192@cornell.UUCP>
Date: 16 Jan 89 19:49:52 GMT
References: <11756@dartvax.Dartmouth.EDU> <13582@cup.portal.com>
Sender: nobody@cornell.UUCP
Reply-To: hal@cs.cornell.edu (Hal Perkins)
Organization: Cornell Univ. CS Dept, Ithaca NY
Lines: 14

In article <...> MacUserLabs@cup.portal.com (Stephan - Somogyi) writes:
>SuperLaserSpool is not a proper init. To the best of my recollection
>the installation procedure does the same as a 'Set Startup' on SLS.
>SLS then quits to the Finder when it's done. SLS is in fact an
>application, therefore it has a CODE 0 that can be messed with.

Old versions of SuperLaserSpool and SuperSpool worked this way, but
the new versions that came with release 7.0 of the DataFrame utilities
are real inits that are installed by just dropping them into the
system folder.  (I'm sure if I'm wrong many people will feel free to
correct me with great enthusiasm.)

Hal Perkins             hal@cs.cornell.edu
Cornell CS