Path: utzoo!attcan!uunet!lll-winken!ames!xanth!ukma!rutgers!njin!princeton!njsmu!mccc!cosi!bill
From: bill@cosi.UUCP (Bill Michaelson)
Newsgroups: comp.text
Subject: Jetroff
Keywords: dwb jetroff
Message-ID: <268@cosi.UUCP>
Date: 11 Jan 89 22:08:26 GMT
Organization: COS, Inc., Lawrenceville, NJ
Lines: 19


Hi all.  I recently got myself a copy of the Jetroff postprocessor, so
I could use my laser printer to do pretty things.  I'm running Microport
System V/386 3.0e with DWB also supplied by Microport.  The installation
process seemed to go pretty smoothly - all compiled well, etc.  I then
tried the make command to produce the documentation which is bundled with
the package.  It produced absolute gobbledegook on the printer.

I've modified the shell script in ...lp/models to support the -otroff
option, and I've set transparency on in the device driver.  My printer is
a LJ clone, but I'm pretty sure it is compatible enough that it isn't the
source of my problem (it responds properly to all LJ commands I send to
it from programs).  I think I'm just overlooking something, but I don't
know where to start.

Any suggestions?
-- 
Bill Michaelson - uh... princeton!mccc!cosi!bill, I think.
also at... Voice 609-771-6705  CompuServe 72416,1026