Path: utzoo!attcan!uunet!wa3wbu!john
From: john@wa3wbu.UUCP (John Gayman)
Newsgroups: comp.unix.microport
Subject: Jetroff and V/386
Message-ID: <205@wa3wbu.UUCP>
Date: 12 Jan 89 02:53:44 GMT
Organization: WA3WBU, Marysville,PA
Lines: 27


     Are any of you net-readers out there currently using Jetroff
with a HPLJII and Microport V/386 ?  

     Are there any other groups/forums where active discussions on 
Jetroff's installation and use are being discussed ?

     My problem seems to be final installation. The code compiles and
installs cleanly for me. But I lack sufficient DWB knowledge to 
figure out the steps right at the end of installation on fine-
tuning the djet/jetroff.sh so it operates correctly with lp. On my
initial attemp I got it to run but when using it to send stuff to the
LaserJet II, all I got was garbage and a few graphic characters. So
I'm certain I was configuring it incorrectly.

     I'm using uport V/386 3.0e with the LJII as lp. If anyone out there
has gone through setting it up and can mail me some pointers I sure
would appreciate it. Thanks.


						John


-- 
John Gayman, WA3WBU              |           UUCP: uunet!wa3wbu!john
1869 Valley Rd.                  |           ARPA: john@wa3wbu.uu.net 
Marysville, PA 17053             |           Packet: WA3WBU @ AK3P