Path: utzoo!utgpu!watmath!uunet!tut.cis.ohio-state.edu!cs.utexas.edu!pp!cadillac!redcloud!rpj
From: rpj@redcloud.cad.mcc.com (Rich Johns)
Newsgroups: gnu.emacs
Subject: gdb+ in emacs
Summary: having trouble
Message-ID: <697@cadillac.CAD.MCC.COM>
Date: 6 Jan 89 16:58:06 GMT
Sender: news@cadillac.CAD.MCC.COM
Reply-To: rpj%cad@MCC.COM (Rich Johns)
Organization: MCC VLSI-CAD Program, Austin, TX
Lines: 20


I am trying to run gdb+ from emacs, ie., M-x gdb. I have gdb.el, it
contains the c++ stuff, it is byte compiled and loaded etc. However,
when I start up I get the following message:

  "wrong type argument: processp, nil"

It then proceeds to display the gdb banner and load the symbol table.
As I move through the code, ie., breakpoints, step, whatever, the
source never gets displayed, nor does, the arrow showing the current
line. I can still use the debugger, but I am hopelessly dependent on
the list command. Anybody have any ideas as to what is going on here?

-- 
Rich Johns, MCC CAD Program | 3500 W. Balcones Center Dr., Austin, TX 78759
ARPA: johns@mcc.com         | Phone: [512] 338-3714
UUCP: {uunet,harvard,gatech,pyramid}!cs.utexas.edu!milano!cadillac!johns
Rich Johns, MCC CAD Program | 3500 W. Balcones Center Dr., Austin, TX 78759
ARPA: johns@mcc.com         | Phone: [512] 338-3714
UUCP: {uunet,harvard,gatech,pyramid}!cs.utexas.edu!milano!cadillac!johns