Path: utzoo!attcan!uunet!lll-winken!ames!mailrus!cwjcc!tut.cis.ohio-state.edu!osu-cis!dsacg1!nfs0294 From: nfs0294@dsacg1.UUCP (Glendell R. Midkiff) Newsgroups: comp.databases Subject: Re: Writing formatted output to file in dBase III+ Message-ID: <626@dsacg1.UUCP> Date: 27 Jan 89 13:23:20 GMT References: <403@systime.UUCP> Organization: Defense Logistics Agency Systems Automation Center, Columbus Lines: 14 From article <403@systime.UUCP>, by staylor@systime.UUCP (Simon Taylor): > Does anyone know how to redirect formatted output generated using @x,y SAY > under dBase III+ rather than to the screen or printer? > I'm not sure if all this is supported by DBASE III+, but in CLIPPER you can use the SET ALTERNATE or SET PRINTER TO and when done close the file by using SET ALTERNATE TO, SET ALTERNATE OFF. -- |-----------------------------------------------------------------------| |Glen Midkiff osu-cis!dsacg1!gmidkiff | | Phone: (614)-238-9643 @DLA, Systems Automation Center, Columbus, Oh. | |-----------------------------------------------------------------------|