Path: utzoo!utgpu!attcan!uunet!lll-winken!ames!killer!vector!nobody
From: dileo@BRL.MIL
Newsgroups: comp.dcom.telecom
Subject: Question regarding 'cut through' codes
Message-ID: <telecom-v09i0021m06@vector.UUCP>
Date: 19 Jan 89 17:57:02 GMT
Sender: chip@vector.UUCP
Lines: 12
Approved: telecom-request@vector.uucp
X-Submissions-To: telecom@bu-cs.bu.edu
X-Administrivia-To: telecom-request@vector.uucp
X-TELECOM-Digest: volume 9, issue 21, message 6


   I have just one question concerning the information contained in the Guide
to NA Area Codes. Immediately before the glossary, "cut through dialing" is
mentioned. This is a technique which I like to use, particularly when my
primary carrier is busy or suffering from sunspots or the like. What I would
like to know is, What are all of the cut through codes which one can use to
specify a carrier for your call. The only one which I know of is 10288, which
gives you an AT&T connection.

   Also, thanks for the copy of the guide.

                                                          --John DiLeo-Lopez