Path: utzoo!attcan!uunet!lll-winken!ncis.llnl.gov!helios.ee.lbl.gov!pasteur!agate!bionet!csd4.milw.wisc.edu!leah!rpi!batcomputer!cornell!uw-beaver!blake!ogccse!littlei!omepd!mipos3!pinkas From: pinkas@hobbit.intel.com (Israel Pinkas ~) Newsgroups: comp.sources.wanted Subject: Re: MGR Part17 needed. Message-ID: Date: 26 Jan 89 18:03:16 GMT References: <197716@hrc.UUCP> Sender: news@mipos3.intel.com Organization: Corporate CAD, INTeL Corporation, Santa Clara, CA Lines: 35 In-reply-to: dan@hrc.UUCP's message of 25 Jan 89 17:41:20 GMT In article <197716@hrc.UUCP> dan@hrc.UUCP (Dan Troxel) writes: > I am missing part17 of the MGR series. I am an archive site and need this > to complete the series. Call me on my nickle at 1-800-777-8870, and ask for > Dan. We can set up a connection and I will pull it off. Telebit site > prefered. If you inspect the shar files, you will find all the parts. There must have been a glitch in the software that Rich uses, as parts 17-20 had part numbers in the subject line that were one higher than they should have been. (There were two parts named 21. They were not duplicates.) The Archive-name field had the wrong part numbers as well. The only way I detected the tru part numbers was to look at the comment at the top of the shar file, where it tells you what message the shar file will print when it is done unpacking. (e.g "End of archive 11 (of 61)".) Note that parts 1, 3, and 4 were reposted, and the reposts were slightly different from the originals. To date, I have 0-30, 33-39. Enjoy, -Israel Pinkas -- -------------------------------------- Disclaimer: The above are my personal opinions, and in no way represent the opinions of Intel Corporation. In no way should the above be taken to be a statement of Intel. UUCP: {amdcad,decwrl,hplabs,oliveb,pur-ee,qantel}!intelca!mipos3!cad001!pinkas ARPA: pinkas%cad001.intel.com@relay.cs.net CSNET: pinkas@cad001.intel.com