Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ulowell!cbmvax!jesup
From: jesup@cbmvax.UUCP (Randell Jesup)
Newsgroups: comp.sys.amiga
Subject: Re: amiga 2500UX
Message-ID: <5852@cbmvax.UUCP>
Date: 30 Jan 89 19:29:50 GMT
References: <5804@cbmvax.UUCP> <5827@cbmvax.UUCP> <14054@cup.portal.com>
Reply-To: jesup@cbmvax.UUCP (Randell Jesup)
Organization: Commodore Technology, West Chester, PA
Lines: 15

In article <14054@cup.portal.com> Bruce_Eric_Bowers@cup.portal.com writes:
>In article <5827@cbmvax.UUCP>, daveh@cbmvax.UUCP (Dave Haynie) says:
>>                              No matter the preset, holding down both
>>mouse buttons at boot time will get you a menu that lets you select the
>>Amiga OS controlled by either the 68020 or the 68000, or UNIX if you have
>>it on your hard disk.
>
>Is this true of any 2500? Does the 68000 still run at 7 MHz?

	A2500's are based on the A2620 board.  All have the boot on 68000
feature, and the 68000 runs at 7.?? Mhz, as usual.  When you boot on the
68000, you lose the memory on the '020 card (the whole board is turned off.)

-- 
Randell Jesup, Commodore Engineering {uunet|rutgers|allegra}!cbmvax!jesup