Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!iuvax!rutgers!rochester!pt.cs.cmu.edu!andrew.cmu.edu!jc58+ From: jc58+@andrew.cmu.edu (Johnny J. Chin) Newsgroups: comp.sys.ibm.pc Subject: Re: AT harddisk in IBM PC Message-ID: <4XsdLXy00V4-Q85Xx-@andrew.cmu.edu> Date: 29 Jan 89 04:41:07 GMT Organization: Carnegie Mellon, Pittsburgh, PA Lines: 40 To install the AT hard disk into the PC is simple. 1. Change the DS (Drive Select) jumper on the drive from DS1 to DS0 by moving the jumper from the second set of pins to the first. 2. Get any Western Digital hard drive controller that supports the 40 Meg. (NOTE: Old versions of WD cards will NOT work.) 3. Get the two necessary cables for the controller card and connect the controller to the drive. Observe the color edge of the cable. The color edge of the cable goes to pin 1 on the controller and the edge of the circuit board on the drive which has a slit in it. 4. Upgrade your power supply to at least 120 Watts, if not 150W. 5. Plug in the power cable from the power supply to the drive. 6. Boot up with a virgin DOS 3.2 or higher disk. 7. Follow the instructions that came with the WD controller on how to do a low level format on the drive, etc. 8. Run FDISK and FORMAT the drive. You should be up and running. Now, as for the 1/2" from the power supply ... DO NOT WORRY ABOUT IT. I have a 40 Meg. (CDC) in mine which is about 1/2" from the power supply and I haven't had any problems. From my work experience, most drives do come that close to the power supply. I hope all of this didn't go over you head and will help you. -- J. Chin (a.k.a. Computer Dr.) xxxxxxxxxx xxx xxx xx ------------------ Carnegie Mellon University ------------------ xxx xxx xx 4730 Centre Ave. #412 ARPAnet: Johnny.J.Chin@andrew.cmu.edu xxxxxxxxxxxx Pittsburgh, PA 15213 BITnet: jc58@andrew.BITNET x xxxxxxxx x (412) 268-8936 UUCP: ...!harvard!andrew.cmu.edu!jc58 xx xx ---------------------------------------------------------------- xxxxxxxxxx Smile! -- Mr. HappyWOWface -- (got this from the network) Disclaimer: The views expressed herein are STRICTLY my own, and not CMU's.