Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!rutgers!ucsd!sdcsvax!ucsdhub!esosun!seismo!uunet!jarthur!pthiesse
From: pthiesse@jarthur.Claremont.EDU (Paul Thiessen)
Newsgroups: comp.sys.ibm.pc
Subject: Re: LPT2 jumpering on SixPackPlus
Summary: setting LPT1 or 2
Keywords: SixPackPlus
Message-ID: <116@jarthur.Claremont.EDU>
Date: 1 Feb 89 21:34:31 GMT
References: <7098@june.cs.washington.edu>
Distribution: usa
Organization: Harvey Mudd College, Claremont, CA
Lines: 13

In article <7098@june.cs.washington.edu>, tanimoto@june.cs.washington.edu 
(Steve Tanimoto) writes:

> Can someone tell me how to jumper by AST SixPackPlus to make
> the parallel printer port LPT2?  Seems I've lost my documentation.
> I have another parallel port and seem to have a collision
> preventing the use of it.  Thanks.

Locate the Port Enable Jumper Block (on the bottom, under the clock battery)
that has 6 pairs of pins. If I'm right, you have a shorting plug at the
third position (from the left). Put it on the fourth. That should work.

             Paul Thiessen