Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ukma!tut.cis.ohio-state.edu!ucbvax!NOBERGEN.BITNET!SINBV From: SINBV@NOBERGEN.BITNET ("Bjoern Asle VALDE +47 21 32 46", 5) Newsgroups: comp.lang.modula2 Subject: re: Does anyone have a make file generator Message-ID: Date: 10 Feb 89 10:11:51 GMT Sender: daemon@ucbvax.BERKELEY.EDU Reply-To: Modula2 List Organization: The Internet Lines: 23 X-Unparsable-Date: Fri, 10 Feb 89 10:44:42 EMT This might not be quite what your looking for, but I have a very nice makefile-generator that currently works with C pograms under ms-dog. It's originally written for unix by Peter J. Nicklin and is ported to dos by a person next door. This thing could quite easily work with turbo-pascal, and it shuld therefore be easy to make it understand M2 also. You'll have to do the changes in C though, rewriting it to M2 is of course possible but migth take a few days depending on the weather and skiing conditions. To the best of my knowledge this code is pd, so send me a note and I'll provide a copy. Eh, if you're using make *only* for dependency analysis on M2 source code is it not quite clear for me why you're not satisfied with the Logitech make, as this make can gather all relevant information from the code -- obviously nice. Last one other thing; the make I'm refering to should probably work with NdMake (that piece is pd too), last time I looked both turbo-make and msmake where to severely braindamaged to be of *real* value in many situasions. Regards; _Bjorn -- edmbv\nobergen (.bitnet/earn) "disclaimer? what - me worry :-)" bjorn\lilje.uib.no (internet) valde\rose.uib.uninett (ean)