Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uflorida!ukma!husc6!purdue!decwrl!mtwain.dec.com!macdonald
From: macdonald@mtwain.dec.com (Paul MacDonald - CUP/ML - 223-3439)
Newsgroups: comp.sys.amiga
Subject: GVP
Message-ID: <8902061643.AA19136@decwrl.dec.com>
Date: 6 Feb 89 18:49:00 GMT
Organization: Digital Equipment Corporation
Lines: 19

Here are a couple problems for ya:

I installed a new GVP 40QS hardcard the other day. GVP has a "click and go"
installation process that makes life so much easier. Everything worked fine
including my restoration of files with Quarterback. I noticed that GVP 
assigned DH0: to the hardcard, even though it's a SCSI device. 

When I tried to reprep my 40 Mbyte ST-506's first partition as DH1: 
(assuming that if DH0: was allocated to the GVP, then DH1: was the only
device assignment available for the first partition of the ST-506), the
Amiga looked at it as DH0:. As a matter of fact, when I did an INFO
command, it showed two DH0:. Of course the GVP could not be accessed, 
since the ST-506 DH0: received precedence. I checked the mountlist and
everything was it should be.

Can anyone comment on this? I would like to be able to use the A2090 and
ST-506 along with the GVP SCSI.

Paul