Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!iuvax!silver!tenbarge
From: tenbarge@silver.bacs.indiana.edu (Kris Tenbarge)
Newsgroups: comp.sys.apple
Subject: kermit question
Keywords: modem commands
Message-ID: <3115@silver.bacs.indiana.edu>
Date: 6 Feb 89 01:42:50 GMT
Organization: Indiana University BACS, Bloomington
Lines: 14

I am a new user of apples.  I use my C= 64 as a vt100 using Kermit for the 64
and would like to set up my girlfriends IIgs with Kermit 3.85.  I have it 
configured for operation but I haven't yet figured out the modem command.  On
On the commmodore version you simply give commands to the modem from the 
connect mode, but I take it Apple Kermit is different.  I wrote a kermit.modem
file using Appleworks and I printed the file to disk in ASCII and then copied
this file to my kermit disk.  When I issued the modem command my file was there
but it had a mysterious extra line and the command simply did not communicate
with the modem.  Is there something I should check to make sure I do.  Is there
another way to send commands to a Hayes comp. modem.  What gives, etc.  I am 
quite familiar with the Commodore version so give me all the details!

Thanks
-Kris Tenbarge