Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!HNYKUN51.BITNET!TOXI_CE
From: TOXI_CE@HNYKUN51.BITNET
Newsgroups: comp.sys.atari.st
Subject: NEC P6 driver voor GDOS
Message-ID: <8902072145.AA16106@ucbvax.Berkeley.EDU>
Date: 7 Feb 89 08:42:00 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 34

Distribution-File:
        "info-atari16@score.stanford.edu"

I am looking for a GDOS device driver that will use the maximum
(360*360 dpi) resolution of a NEC P6 24 needle printer. Does it exist?

I have a little program that emulates a fx80 on the NEC, and I can
use that in combination with fx80.sys and output.prg, but the results
are not better (even slightly worse) than on a real 9 needle printer.

If such a device driver exists, it will need need special fonts,
are these available to?

I heard a lot about G+PLUS, it should be better and faster than GDOS (?).
Is true?
Where can I get it?

                        Chris Evelo
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

                             Chris Evelo

                             TOXI_CE@HNYKUN51 (BITNET/EARN)
                                 |
                                 an underscore _ not -.

                Mail adress: Department of Toxicology
                             University of Nijmegen
                             Kapittelweg 54
                             6525 EP Nijmegen
                             The Netherlands
                             tel. 080-517184/514206

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++