Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ames!xanth!nic.MR.NET!umn-cs!bungia!cimcor!jim_d
From: jim_d@cimcor.mn.org (Jim Dahlberg)
Newsgroups: comp.sys.ibm.pc
Subject: Telix problem
Message-ID: <642@cimcor.mn.org>
Date: 6 Feb 89 03:27:26 GMT
Organization: Grenier & friends, Forest Lake, MN
Lines: 17

I have had a problem using Telix 3.11 at work, where I would like to switch
between using it with an internal modem and a direct-connect serial
port.  Unfortunately, it doesn't work.

The modem is 1200 baud on com3: (I have to tell Telix it is on com4: to
get it to work).  The direct-connect port is on com2: and runs at 19200
baud.

The only way to get either of these ports to work is to make it the
default port that gets initialized when I start up Telix.  If I try to
switch to the other port while running Telix, it doesn't work.  I get no
response from either the modem or the direct-connect port, depending on
which one I am trying to switch to. 

    Jim Dahlberg
    Internet: jim_d@cimcor.mn.org
    UUCP:     uunet!rosevax!cimcor!jim_d