Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!bionet!agate!ucbvax!decwrl!megatest!palowoda
From: palowoda@megatest.UUCP (Bob Palowoda)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Telix problem
Message-ID: <1625@megatest.UUCP>
Date: 7 Feb 89 06:05:42 GMT
References: <642@cimcor.mn.org>
Organization: Megatest Corporation, San Jose, Ca
Lines: 21

From article <642@cimcor.mn.org>, by jim_d@cimcor.mn.org (Jim Dahlberg):
> I have had a problem using Telix 3.11 at work, where I would like to switch
> between using it with an internal modem and a direct-connect serial
> port.  Unfortunately, it doesn't work.
> 
> The modem is 1200 baud on com3: (I have to tell Telix it is on com4: to
> get it to work).  The direct-connect port is on com2: and runs at 19200
> baud.
  
   Still sounds as if you have hardware problems. I use Telix on comm3
   int2 (I cut the interupt line and move it on one of those el'cheapo
   rs232 cards) and a external modem on com2(int3), and a mouse on
   com1(int 4). 
   Telix switches back and forth between the ports just fine. I'm 
   running at 9600 into a Xenix machine direct on comm3. 19.2k shows
   to much jerky sceen updates. Use int5 on an AT.        
-- 
 Bob Palowoda                               
 Work: {sun,decwrl,pyramid}!megatest!palowoda                           
 Home: {sun,pryamid}aeras!grinch!legends!fiver!palowoda                
 BBS:  (415)796-3686 2400/1200   Voice:(415)745-7749