Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uflorida!ukma!tut.cis.ohio-state.edu!osu-cis!att!ihlpf!joelynn
From: joelynn@ihlpf.ATT.COM (Lynn)
Newsgroups: comp.sys.tandy
Subject: PEEK/POKE addresses
Message-ID: <7602@ihlpf.ATT.COM>
Date: 6 Feb 89 20:23:10 GMT
Organization: AT&T Bell Laboratories - Naperville, Illinois
Lines: 13


Can anyone tell me what address to read/write to change the time
that my Tandy 1400LT stay's active?

I have an application that takes hours at times, and the 1400 times out
after 3 hours and 10 minutes, and goes into a "stand by" mode.  I need to
change this.  I tried the alt-cont-ins keys and the longest I can set
the timer for is 3:10

Also, what address can I "PEEK" at to determine what computer
the program is running on.  One simple application would be a program
that I run on my 6300+ and the 1400LT.  How can I write a program
to determine which computer the program is running on?