Path: utzoo!attcan!uunet!ispi!jbayer
From: jbayer@ispi.UUCP (Jonathan Bayer)
Newsgroups: comp.unix.xenix
Subject: Re: lp waits and waits and waits... (and a VP/ix bitch)
Message-ID: <445@ispi.UUCP>
Date: 5 Feb 89 18:03:27 GMT
References: <8589@dasys1.UUCP>
Reply-To: jbayer@ispi.UUCP (Jonathan Bayer)
Organization: Intelligent Software Products, Inc.
Lines: 37

In article <8589@dasys1.UUCP> tbetz@dasys1.UUCP (Tom Betz) writes:
>Finally got Xenix up and running on the 3216 (after Wyse installed a new
	[deleted]
>failed) lp now refuses to send anything to the printer!  I can cat stuff 
>directly to /dev/tty2a (to which lp has been directed to send stuff) but
>if I pipe the same stuff to lp, lp just keeps queing requests up and 
>holding them.  lpstat -s returns:
>
>scheduler is running
>system default destination: laserjet
>device for laserjet: /dev/tty2a
>
>I can't figure it, I can't find anything in the docs that suggests a solution.
>

Check the printer spool directory.  Sometimes there is a file that
shouldn't be there.  If that doesn't work then do the following steps:

	1.	Remove all printers from the lp system.
	2.	Make sure all printer-related files are gone.
	3.	Re-install the laserjet printer on the lp system.

If the above doesn't work then do the following:

	1.	Remove the printer subsystem from Xenix.
	2.	Re-install the printer subsystem.
	3.	Re-install the laserjet.

One  of the above should do the trick.

JB

-- 
Jonathan Bayer			      Beware: The light at the end of the
Intelligent Software Products, Inc.	      tunnel may be an oncoming dragon
19 Virginia Ave.				...uunet!ispi!jbayer
Rockville Centre, NY 11570  (516) 766-2867    jbayer@ispi