Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!rutgers!deimos.cis.ksu.edu!uxc!tank!shamash!com50!questar!bthpyd!holter
From: holter@bthpyd.UUCP (Holter)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: Problems with NCSA Telnet and NI5210
Message-ID: <357@bthpyd.UUCP>
Date: 17 Feb 89 20:15:34 GMT
Reply-To: holter@bthpyd.UUCP (Holter)
Distribution: usa
Organization: Bethel College, St. Paul, MN
Lines: 18


	I have been trying to install a MICOM-Interlan, Inc. Ethernet
card (model NI5210) in a Zenith 159 PC (640k, 2 floppies, 20mb Seagate
hard disk, Paradise autoswitch EGA video card).  The software 
I am using is NCSA Telnet for the PC (version 2.2).  Micom's 
diagnostic program (NI5210DG.EXE) runs successfully after the board 
is installed. The problem occurs when I try running the Telnet software.  
The Telnet software locks up the computer after the message "NCSA Telnet, 
reading configuration file..." is displayed on the screen.  I have 
tried changing the configuration file without success.  The parameters
within the configuration file seem appropriate for our installation.  Has
anyone else experienced difficulty installing the above hardware/software
configuration on their network?  Any help regarding this problem would
be greatly appreciated.

--
Dave Holter,  System Manager		[amdahl!bungia!bthpyd!holter]
Bethel College, St. Paul  MN