Path: utzoo!utgpu!utstat!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!apple!oliveb!tymix!antares!jms
From: jms@antares.UUCP (Joe Smith)
Newsgroups: comp.sys.amiga
Subject: Re: Change DEFAULT TOOL from CLI?
Message-ID: <401@antares.UUCP>
Date: 24 Feb 89 06:49:02 GMT
References: <1222@esunix.UUCP>
Reply-To: jms@antares.UUCP (Joe Smith)
Organization: Tymnet QSATS, San Jose CA
Lines: 20

In article <1222@esunix.UUCP> blgardne@esunix.UUCP (Blaine Gardner) writes:
>I'm looking for a program that will set the DEFAULT TOOL and TOOL TYPES
>arrays from the CLI. I've got over a hundred icons that I need to change
>the Default Tool on, and Workbench's Info option is just too slow.

I can't believe the delay that is visible when you click the close gadget
on the Info window when dmouse is running.  The window is completely cleared
to blue, the stack, comment, and tool types fields written in white text,
the black and orange sections filled it, then the window is closed.  Takes
a bit of a long time.

Actually, it only occurs if you click outside the Info window (which brings
up the ZZ cloud) and then bring the pointer into the Info window.  At this
point the Info window is up front, is active, but Workbench is confused.
Too bad it goes thru all that work for nothing.
-- 
Joe Smith (408)922-6220 | jms@antares.Tymnet.COM or jms@opus.Tymnet.COM
McDonnell Douglas FSCO  | UUCP: ...!{ames,pyramid}!oliveb!tymix!antares!jms
PO Box 49019, MS-D21    | PDP-10:JMS@F74.Tymnet.COM  CA license plate:"POPJ P,"
San Jose, CA 95161-9019 | narrator.device: "I didn't say that, my Amiga did!"