Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!rutgers!psuvax1!vu-vlsi!dsinc!syd
From: syd@dsinc.UUCP (Syd Weinstein)
Newsgroups: comp.sys.apollo
Subject: 2nd drive on apollo DN4500
Message-ID: <65@dsinc.UUCP>
Date: 21 Feb 89 02:23:49 GMT
Organization: Datacomp Systems, Inc., Huntingdon Valley, PA
Lines: 19

I am trying to place a second ESDI disk onto my Apollo DN4500 under
SR10.1.

I added a daisy chain cable to the disk controller and plugged in
the two small cables.  I made the existing drive drive 0 and the
new drive drive 1.

The self test at power up does not see the second drive and the select
light never comes on.  However, the drive is good, I tested it on another
ESDI machine and it works fine.

If I run invol and specify w1, I get a crash.

Any suggestions?
-- 
=====================================================================
Sydney S. Weinstein, CDP, CCP                   Elm Coordinator
Datacomp Systems, Inc.				Voice: (215) 947-9900
{allegra,bpa,vu-vlsi}!dsinc!syd	                FAX:   (215) 938-0235