Xref: utzoo comp.sys.ibm.pc:24844 comp.unix.xenix:5022
Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!leah!itsgw!steinmetz!uunet!ispi!jbayer
From: jbayer@ispi.UUCP (Jonathan Bayer)
Newsgroups: comp.sys.ibm.pc,comp.unix.xenix
Subject: Re: Everex Step 386/20 -- Power-up problems!
Message-ID: <463@ispi.UUCP>
Date: 16 Feb 89 15:18:50 GMT
References: <1989Feb14.175249.25055@ateng.ateng.com>
Reply-To: jbayer@ispi.UUCP (Jonathan Bayer)
Organization: Intelligent Software Products, Inc.
Lines: 35

In article <1989Feb14.175249.25055@ateng.ateng.com> chip@ateng.ateng.com (Chip Salzenberg) writes:
>Once upon a time, A T Engineering bought several Everex Step 386/20

>If you powered them on while the printer was on and connected, they were
>dead.  Nothing.  Nada.  Not even the fancy front panel display.

>This problem was nothing more than a nuisance until we found that the same
>problem would be caused by leaving an Archive tape drive on and plugged in.
>Of course, the Xenix drivers for the Archive only look for the tape at
>power-up, so if you turn off the drive so the computer will start, then you
>can't use the tape at all.  And trying to use the tape with the computer
 ^^^^^^^^^^^^^^^^^^^^^^^^^
	Not so.  Do the following command and the tape drive will work OK:

		tape reset

		and wait until the drive finishes resetting.


>
>So has anyone else had this trouble with Everex Step 386 motherboards?  Are
>we the only Everex users with printers and Archive tapes?  What's going on?


We're running a Step 25 here, with no problems such as you described.




JB
-- 
Jonathan Bayer			      Beware: The light at the end of the
Intelligent Software Products, Inc.	      tunnel may be an oncoming dragon
19 Virginia Ave.				...uunet!ispi!jbayer
Rockville Centre, NY 11570  (516) 766-2867    jbayer@ispi.UUCP