Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!apple!han
From: han@Apple.COM (Byron Han, Architect)
Newsgroups: comp.sys.mac.programmer
Subject: Re: MPW 3.0's Print command
Message-ID: <26394@apple.Apple.COM>
Date: 26 Feb 89 04:10:26 GMT
References: <2805@nunki.usc.edu>
Organization: Apple Products - Networking & Communications
Lines: 22

article <2805@nunki.usc.edu> malczews@castor.usc.edu (Frank Malczewski) writes:
> the printing of the LQ Imagewriter to be quite slow in Best quality mode,
>which is the only mode that (apparently) works with the print command.  

Have you tried the commando interface for the print command?  It has 
(on the more options page) the ability to specify the quality of the printing.

print -q high/print -q standard/print -q draft are three possible options.

Hope this helps.  (I don't know if this works with the LQ since I don't have
one but give it a whirl)
+-----------------------------------------------------------------------------+
| Disclaimer: Apple has no connection with my postings.                       |
+-----------------------------------------------------------------------------+ 
Byron Han, Communications Architect      Cereal, anyone?  :-)
Apple Computer, Inc.                     -------------------------------------
20525 Mariani Ave, MS27Y                 Internet: han@apple.COM
Cupertino, CA 95014                      UUCP:{sun,voder,nsc,decwrl}!apple!han
--------------------------------------   GENIE: BYRONHAN
ATTnet: 408-974-6450   Applelink: HAN1   CompuServe: 72167,1664
------------------------------------------------------------------------------