Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!rutgers!bellcore!faline!thumper!ulysses!mhuxo!mhuxu!jmj
From: jmj@mhuxu.UUCP (J. M. Johnson)
Newsgroups: comp.sys.tandy
Subject: Re: Problem with Hard Card
Summary: SMWCLOCK.COM can't find SmartWatch on controller card.
Message-ID: <9127@mhuxu.UUCP>
Date: 24 Feb 89 17:39:11 GMT
References: <920@cs.rit.edu> <136500010@cpe>
Organization: AT&T Bell Laboratories, Murray Hill
Lines: 29

In article <136500010@cpe>, steve@cpe.UUCP writes:
>
>   As for the SmartWatch, it can be installed on the hard disk card thereby
>   allowing the use of slot number one for the hard card.  Simply pull the
>   SmartWatch out of SX and install it under the BIOS of the hard disk
>   card.  Make sure that both SmartWatch and BIOS are oriented correctly.
> 
>				           Stephen L. Osborn
>				           Computer Products Engineering
>				           Tandy Corporation/Radio Shack

I'm very happy to see a Tandy employee on the net.

About putting the SmartWatch on the hardcard controller board, I tried
this and SMWCLOCK.COM couldn't find the clock.  I would like to be able
to move the hardcard over to slot five (the slot next to the p. s. is
numbered five here) for better cooling, but I also would like to have
my clock.  Do I need to patch the program to enable it to find the clock
on the controller?

Other than this problem, I have been very happy with the 1000SX since
I purchased it in 12/86.

PS.  Are there any job openings there?  Big layoff here. :-(

-- 
       Life's just a game, you fly a paper plane, there is no end. - TBA

J. M. Johnson, AT&T Bell Laboratories, Reading, PA       ...!att!mhuxu!jmj