Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!rutgers!bellcore!dana From: dana@dino.bellcore.com (Dana A. Chee) Newsgroups: comp.windows.x Subject: Re: xfig. Message-ID: Date: 21 Feb 89 14:16:39 GMT References: <8902171809.AA12137@DORA.MIT.EDU> Sender: news@bellcore.bellcore.com Organization: Bellcore, Morristown, NJ USA Lines: 31 In-reply-to: kit@ATHENA.MIT.EDU's message of 17 Feb 89 18:09:34 GMT In article <8902171809.AA12137@DORA.MIT.EDU> kit@ATHENA.MIT.EDU (Chris D. Peterson) writes: [ venky@cs.buffalo.edu (Ramadoss Venkatesan) writes: ] > Could someone tell me from where I can ftp the source, makefile, manual pages > etc. for XFIG? There is a version on the X11R3 contrib tape. There is also a version on expo in oldcontrib/xfig. I do not have any idea what versions these are or even if they are different. All I know is that something exists in each of these places that calls itself xfig. Chris D. Peterson MIT X Consortium / Project Athena The xfig in oldcontrib is pre R3. I don't believe it has all of the patches available. The xfig on the contrib tape for R3 is the current version. It has three patches which bring it completely (?) up to date. They are available from the comp.sources.x archives as xfig patches 4-6 (1-3 were for xfig from R2), or from expo in the files xfig.r3.patch[1-3]. -- +*************************************************************************+ * Dana Chee (201) 829-4488 * * Bellcore * * Room 2Q-250 * * 445 South Street ARPA: dana@bellcore.com * * Morristown, NJ 07960-1910 UUCP: {gateways}!bellcore!dana * +*************************************************************************+