Path: utzoo!utgpu!utstat!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!decwrl!labrea!rutgers!psuvax1!psuvm.bitnet!cunyvm!ndsuvm1.bitnet!ud140469
From: UD140469@NDSUVM1.BITNET
Newsgroups: comp.graphics
Subject: DXF conversion
Message-ID: <1939UD140469@NDSUVM1>
Date: 28 Feb 89 03:10:53 GMT
Organization: North Dakota Higher Education Computer Network, Fargo, ND
Lines: 12
DISCLAIMER: Author bears full responsibility for contents of this article.

Sorry for treading into comp.graphics with what is probably a much overused
request, but here goes anyway.  I'm looking for a utility (or code) to convert
those good old DXF files into simple wireframe (2d or 3d) objects defined with
just points and lines.  As I mentioned above, a pre-existing utility would be
great, but code in either Pascal or C would do also.  Please mail me responses
if this has already been covered a lot here.

                                        Thanks a lot!
                                        Scott Udell
                                        UD140469@NDSUVM1.BITNET

From still frosty North Dakota