Path: utzoo!utgpu!utstat!jarvis.csri.toronto.edu!mailrus!purdue!decwrl!sun!pitstop!sundc!seismo!uunet!super!rminnich
From: rminnich@super.ORG (Ronald G Minnich)
Newsgroups: comp.sys.amiga
Subject: Re: KA9Q TCP/IP
Message-ID: <6857@super.ORG>
Date: 8 Mar 89 15:33:51 GMT
References: <3076@watale.waterloo.edu>
Sender: news@super.ORG
Reply-To: rminnich@kent.UUCP (Ronald G Minnich)
Organization: Supercomputing Research Center, Lanham, Md.
Lines: 9

In article <3076@watale.waterloo.edu> guest@surya.waterloo.edu (Barry Kahl) writes:
>trying to figure out what address, and interrupt to specify for the
>"attach asy" command.  And I suspect that I will have other problems
well, you don't need either since it always uses serial.device.
If i remember right (i am at work) 
just use 0 for address and interrupt. Use your baud rate for the 
baud rate, and all else follows the standard PC ka9q.
Good luck,
ron