Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!oberon!nunki.usc.edu!sal61.usc.edu!rjung
From: rjung@sal61.usc.edu (Robert  allen Jung)
Newsgroups: comp.sys.atari.st
Subject: Re: Atari ST Screen Dump Info Sought
Message-ID: <2897@nunki.usc.edu>
Date: 2 Mar 89 17:08:36 GMT
References: <3958@druhi.ATT.COM> <1396@csd4.milw.wisc.edu>
Sender: news@nunki.usc.edu
Reply-To: rjung@sal61.usc.edu (Robert  allen Jung)
Organization: University of Southern California, Los Angeles, CA
Lines: 26

In article <1396@csd4.milw.wisc.edu> johnnyd@csd4.milw.wisc.edu (Johnny D) writes:
>In article <3958@druhi.ATT.COM> terrell@druhi.UUCP (TerrellE) writes:
>|My question is this:  Does this screen dump work with non EPSON compatible
>|printers?
>
>    The screen dump works fine on my Panasonic 1091i, although I only get 
>3/4 of the screen since it's an 80 column printer.  As far as I know,
>the screen dump should work with any IBM compatible dot matrix printer.

  Not necessarily, since the Panasonic 1091 is Epson compatable (at least mine
is).

  And by the way, the reason you're getting 3/4ths of the screen is probably
not due to 80 columns, but because the ST thinks you have 1250 dots across.
Try using the Control Panel to "Set Printer" to 960 dots, and see if that
improves the situation.

						--R.J.
						B-)

 =============================================================================
                 Disclaimer: This message was written with my authorization
      # ## #
      # ## #     Mailing address: rjung@nunki.usc.edu
     ## ## ##          (It's easier to just use the reply function, tho)
  ####  ##  ####