Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!UDEM.BITNET!CHIASSA
From: CHIASSA@UDEM.BITNET (Alyre CHIASSON)
Newsgroups: comp.sys.atari.st
Subject: STAR NX-2400 PRINTER AND FIRST WORD PLUS  V. 2.02
Message-ID: <ID4730.D890307.T165344.CHIASSA@UDEM>
Date: 7 Mar 89 20:53:44 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 16


 I just purchased an Star NX-2400 printer and am trying to
 configure the driver to give me the best graphic resolution
 with FIRST WORD PLUS.  I can get it to work at 8-bit
 Single-density(60dpi) but this is far below what the
 printer is capable of doing. If you have managed to
 obtain a better resolution could you let me know
 what you used for the linefeed in printer units D (first
 line of the driver), pixels/inch (first line of the driver),
 and the start graphics command. If you known that
 60dpi is the resolution limit imposed by the software I
 would also appreciate the message.

 Many thanks

 Alyre Chiasson