Path: utzoo!attcan!uunet!lll-winken!csd4.milw.wisc.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!nasamail.nasa.gov!awilkinson From: awilkinson@nasamail.nasa.gov (ALLEN R. WILKINSON) Newsgroups: comp.sys.transputer Subject: 3LUSERS.DOC to TCGOULD Message-ID: Date: 1 Mar 89 21:56:00 GMT Sender: daemon@ucbvax.BERKELEY.EDU Organization: The Internet Lines: 36 3-1-89 Transputer Community, I am a new member on the Bulletin Board. I use T800's in TRAMs on an INMOS B008 board in a Dell System 310 (80386 20MHz PC) under MSDOS 3.3. I have the INMOS D700D development system, but currently favor 3L's parallel FORTRAN V2.0.1 with afserver under DOS. I would like to identify other users of this FORTRAN to share debug ideas with. Currently I am stuck with "worker tasks" not working properly on T8's out on a network. I use the "flood fill" configurer and INCLUDE THREAD.INC and NET.INC to execute communications between root & slave T8's. The "flood fill" configuration mode works for the 3L supplied Mandelbrot Set generator program. I apparently don't understand proper useage of the parallel FORTRAN run time libraries THREAD.INC & NET.INC. Any veterans out there with advice? Here is my complete mailing address: Dr. Allen Wilkinson NASA Lewis Research Center MS 500-217 21000 Brookpark Road Cleveland, OH 44135 USA (phone) (216) 433-2075 (FTS) 297-2075 (fax) (216) 433-8000 (telemail) [AWILKINSON/NASA] NASAMAIL USA (INTERNET) (AWILKINSON@NASAMAIL.NASA.GOV) (BITNET) (AWILKINSON%NASAMAIL@AMES.ARC.NASA.GOV) Allen Wilkinson