Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!leah!rpi!batcomputer!cornell!rochester!pt.cs.cmu.edu!andrew.cmu.edu!mp1u+ From: mp1u+@andrew.cmu.edu (Michael Portuesi) Newsgroups: comp.sys.amiga.tech Subject: Re: MicroBotics SCSI woes Message-ID: Date: 16 Mar 89 20:16:52 GMT References: <1524@ucsd.EDU> Organization: Mathematics, Carnegie Mellon, Pittsburgh, PA Lines: 18 In-Reply-To: <1524@ucsd.EDU> hutch@net1.ucsd.edu (Jim Hutchison) writes: > Where the problem comes in is > talking to the device. MicroBotics does not include any suggestions > on how to send SCSI commands to the device driver so that you can send > setup commands to the SCSI device on the other end (an OMTI controller). Matt Dillon has done exactly what you want. It used to be avaialble by FTP from ucbvax.berekeley.edu, but it's not there any more. You might want to send Matt mail and ask about the details, if he hasn't already seen this discussion thread and helped you already. -- Michael Portuesi / Information Technology Center / Carnegie Mellon University INET: mp1u+@andrew.cmu.edu / BITNET: mp1u+@andrew UUCP: ...harvard!andrew.cmu.edu!mp1u+ "You just don't get off a spaceship and run." --Avon