Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cornell!uw-beaver!blake!ogccse!jaglak
From: jaglak@ogccse.ogc.edu (Kevin Jagla)
Newsgroups: comp.sys.ibm.pc
Subject: Re: AT&T 3.3 Dos
Summary: Hard Disk Problem
Keywords: PC6300 DOS UPGRADE
Message-ID: <2076@ogccse.ogc.edu>
Date: 15 Mar 89 23:16:41 GMT
Reply-To: jaglak@ogccse.UUCP (Kevin Jagla)
Distribution: na
Organization: Oregon Graduate Center, Beaverton, OR
Lines: 14

I recently purchased the upgrade package for Micografx Draw Plus
To install this I needed to upgrade my DOS from 2.11 to 3.0 or
higher. So I purchased a copy of AT&T's 3.3 DOS. I followed the 
instructions and installed the 3.3 without completely reformatting.
The result was my 20Mb ST-225 drive would go off on what appeared to
be a seek and never return. 
So I took the system down, and re-installed the DOS 3.3 complete with
a reformat. Once again my drive was unable to operate, (red light on
no further results). This re-format was the idea of AT&T when I made
a service call. 
I reformatted to 2.11 again, and now I am up and running, lots of 
room! But I still can't install Draw Plus. 
1. Has this type of problem been experienced by anyone else? If so
what do I need to do that I have not done??