Xref: utzoo comp.os.os9:408 comp.sys.m6809:1033
Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!wasatch!cs.utexas.edu!rutgers!bellcore!faline!thumper!ulysses!att!chinet!mcdchg!clyde!ag@floyd.ATT.COM
From: ag@floyd.ATT.COM
Newsgroups: comp.os.os9,comp.sys.m6809
Subject: Re: Parallel Printer Driver/Descriptor
Message-ID: <42423@clyde.ATT.COM>
Date: 14 Mar 89 15:35:15 GMT
References: <42053@clyde.ATT.COM> <1477@umbio.MIAMI.EDU>
Sender: nuucp@clyde.ATT.COM
Reply-To: ag@floyd.UUCP (Agesino Primatic)
Organization: AT&T Bell Laboratories, Whippany NJ
Lines: 32

In article <1477@umbio.MIAMI.EDU> dnelson@umbio.MIAMI.EDU (Dru Nelson) writes:
>in article <42053@clyde.ATT.COM>, ag@floyd.ATT.COM says:
>> Xref: umbio comp.os.os9:394 comp.sys.m6809:220
>> 
>> I'm looking for a parallel printer driver that supports the J&M Disk
>> Controller with the parallel port.  There was such an animal a while
>> back on Delphi, but it has disappeared.  Any info would be appreciated....
>>
>
>As promised
>
>p1.dr
>
> (Rest of code deleted....)

OK, that's wonderful.  Now, my biggest problem is how to assemble this
using RMA, my whiz-bang brand-spanking-new assembler from RS.  I don't
have ASM (which is getting to be a major inconvenience), and I can't
seem to find a way to get the linker to write the module header correctly,
specifically the mode byte at 0x0d.  Any suggestions?  I'm not entering
this by hand!!!

-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
         ________
        /_______/|       __________________________
        |       ||----->/                         /     Ag Primatic
        |       ||<----/_________________________/      ag@floyd.ATT.com
        |_______|/    / / / /   / /   / / /   / /
       /oooooooo/    /_________________________/
      /oooooooo/
      ---------
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=