Xref: utzoo comp.os.os9:410 comp.sys.m6809:1034
Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!iuvax!rutgers!cmcl2!esquire!wynkoop
From: wynkoop@esquire.UUCP (Brett Wynkoop)
Newsgroups: comp.os.os9,comp.sys.m6809
Subject: Re: Parallel Printer Driver/Descriptor
Message-ID: <1081@esquire.UUCP>
Date: 16 Mar 89 22:48:18 GMT
References: <42053@clyde.ATT.COM> <1477@umbio.MIAMI.EDU> <42423@clyde.ATT.COM>
Reply-To: wynkoop@esquire.UUCP (Brett Wynkoop)
Organization: DP&W, New York, NY
Lines: 35

In article <42423@clyde.ATT.COM> ag@floyd.UUCP (Agesino Primatic) writes:
>In article <1477@umbio.MIAMI.EDU> dnelson@umbio.MIAMI.EDU (Dru Nelson) writes:
>>in article <42053@clyde.ATT.COM>, ag@floyd.ATT.COM says:
>>> Xref: umbio comp.os.os9:394 comp.sys.m6809:220
>>> 
>>> I'm looking for a parallel printer driver that supports the J&M Disk
>>> Controller with the parallel port.  There was such an animal a while
>>> back on Delphi, but it has disappeared.  Any info would be appreciated....
>>>
>>
>>As promised
>>
>>p1.dr
>>
>> (Rest of code deleted....)
>
>OK, that's wonderful.  Now, my biggest problem is how to assemble this
>using RMA, my whiz-bang brand-spanking-new assembler from RS.  I don't
>have ASM (which is getting to be a major inconvenience), and I can't
>seem to find a way to get the linker to write the module header correctly,
>specifically the mode byte at 0x0d.  Any suggestions?  I'm not entering
>this by hand!!!


Greeting-
     Go to radio shack and buy the upgrade to v2.00 of level 1.  It has a
lot of utilities you need anyway, as well as an asembler that will handle
the job.  It only costs $25.  It is part # 26-3030.  If they do not have it
then ask them to order it for you.

-Brett



uucp .....cmcl2!esquire!wynkoop