Path: utzoo!attcan!uunet!tank!ncar!boulder!sunybcs!rutgers!orstcs!mist!gillisb
From: gillisb@mist.cs.orst.edu (Brian Gillis)
Newsgroups: comp.unix.xenix
Subject: Re: panic - unknown interrupt
Keywords: Printer
Message-ID: <9372@orstcs.CS.ORST.EDU>
Date: 11 Mar 89 06:44:08 GMT
References: <69@subch.UUCP>
Sender: usenet@orstcs.CS.ORST.EDU
Reply-To: gillisb@gsd.UUCP (Brian Gillis)
Distribution: comp
Organization: Gillis Software & Development - Eugene, Oregon
Lines: 18

In article <69@subch.UUCP> maxim%subch@impch.UUCP (Maxim Samo) writes:
>I am running SCO Xenix V 2.2.1 on a 80286. The following problem turned up
>today:
>
>When I try to access my printer (either with cat or lp) when the printer is
>turned off I get the following panic:
>
>panic - interrupt from unknown device   vec=2
>
>Any ideas?

I had that problem with SCO Xenix/386 on a Tandy 4000.
When I called SCO about it,  they had a little patch for it.

Good Luck,
Brian Gillis
gillisb@gsd.UUCP
hp-pcd!gsd!gillisb