Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ncar!ames!killer!rpp386!vector!chip
From: chip@vector.UUCP (Chip Rosenthal)
Newsgroups: comp.unix.xenix
Subject: Re: "exited with status 2"  Help Requested
Message-ID: <724@vector.UUCP>
Date: 13 Mar 89 15:47:22 GMT
References: <1406@nc386.UUCP>
Reply-To: chip@vector.UUCP (Chip Rosenthal)
Distribution: na
Organization: Dallas Semiconductor
Lines: 13

In article <1406@nc386.UUCP> rhg@nc386.UUCP (Rich Garrett) writes:
[describes exit code 2 diagnostic when smail runs]

My guess is that you are running an old version of 2.2 development system.
There is a bug such that "return()" from main() was not the same as
"exit()".  Guess which one smail uses??

Two possible solutions:  (1) change the "return" to an "exit" in smail,
(2) contact sco for the development system maintenance disk "UFC1".
(Sorry, I don't have the official name...just the label on the floppy.)
-- 
Chip Rosenthal     chip@vector.UUCP    |      Choke me in the shallow water
Dallas Semiconductor   214-450-5337    |         before I get too deep.